Thursday, September 21, 2017

Sponsors

I measured the second-generation T 5 p headphones using a G.R.A.S. Model 43AG ear/cheek simulator, a Clio 10 FW audio analyzer, a laptop computer running TrueRTA software with an M-Audio MobilePre USB audio interface, and a Musical Fidelity V-CAN headphone amplifier. This is a “flat” measurement; no diffuse-field or free-field compensation curve was employed.

Frequency response

Although the frequency response of the T 5 p headphones looks somewhat uneven, the measurement suggests a fairly flat overall tonal balance, with a little extra energy around 8kHz -- which is probably why I perceived the sound as being slightly bright.

Frequency response

Adding 70 ohms output impedance to the V-Can’s 5 ohms to simulate the effects of using a typical low-quality headphone amp shows that the T 5 p’s are only subtly sensitive to the source impedance, with a boost of about 1dB in the bass and treble response reduced by about 0.5dB. Thus, with a high-impedance source, the T 5 p should sound slightly warmer.

Frequency response

This chart of the Beyerdynamics’ measured treble response is more or less within the ballpark for high-end headphones. However, their bass response appears to be stronger than average for audiophile headphones -- stronger than Audeze’s closed-back, planar-magnetic LCD-XCs, or Sennheiser’s open-back, dynamic-driver HD 800 Ses.

Waterfall

The spectral decay (waterfall) plot of the Beyerdynamics is fairly clean, with just one pretty well-damped resonance at 8kHz (this corresponds with the response peak at that frequency), and less bass resonance than I usually measure in closed-back ’phones.

THD

The total harmonic distortion (THD) of the T 5 p’s is low, evident only in the bottom octave of bass and only at high listening levels. Note that most of the distortion harmonics remain within the bass range; e.g., the fifth harmonic of 30Hz is 150Hz.

Isolation

In this chart, the level of external noise is 75dB SPL; numbers below that indicate the degree of attenuation of outside sounds. The T 5 p’s provide a little more isolation from such sounds than do Audeze’s LCD-XCs, another audiophile-oriented, closed-back headphone model.

Impedance

The impedance of the T 5 p’s is fairly flat, ranging from 32 to 45 ohms with a relatively flat phase curve.

The Beyerdynamics’ sensitivity, measured between 300Hz and 3kHz with a 1mW signal calculated for the specified 32 ohms impedance, is 103.4dB. That’s fantastic for large, audiophile-oriented headphones, and enough to ensure loud volume from almost any source device.

. . . Brent Butterworth
This email address is being protected from spambots. You need JavaScript enabled to view it.

This site is the main portal for
SoundStage!

All contents available on this website are copyrighted by SoundStage!® and Schneider Publishing Inc., unless otherwise noted. All rights reserved.

This site was designed by Rocket Theme, Karen Fanas, and The SoundStage! Network.
To contact us, please e-mail info@soundstagenetwork.com

SoundStageNetwork.com | SoundStage.com